Axis Wake Research Om 2012 Specifications Page 71
- Page / 90
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
4-12
Care and Maintenance
Miscellaneous
Hardware
Most of the metal hardware on your boat consists of brass, stainless steel, or aluminum
and should be cleaned on a periodic basis with soap and water. In fresh water, metal
fittings and hardware should be sprayed regularly with a rust inhibitor, and after every
use in saltwater.
DO NOT use cleaners that are not intended for use on stainless steel. Glass, tile, counter
or citrus cleaners can damage hardware permanently. Always follow cleaning, by
applying a high-quality metal polish or automotive wax after cleaning. Test products in
an inconspicuous area before applying to the complete surface, especially if you are not
familiar with the product.
All metal parts, including but not limited to tower accessories, board racks or speaker
cans, should be cleaned with mild soap and water frequently and waxed periodically. A
corrosion protectant is highly recommended on these components for use in areas of
salt/brackish water. Pitting or oxidation is not covered under warranty. Pitting is not the
same as separation.
Bilge
The bilge of your boat can accumulate oil and greasy dirt over a period of time and
should be cleaned out periodically. Usually, ordinary soap and water does not remove the
accumulation and something stronger will be needed. Check with your Axis dealer for
recommendations.
Windows and Windshields
The windows and windshields on your Axis boat are made of tempered safety glass and
are similar to the windows in your car. The glass will scratch however, and abrasive
cleaners should not be used to clean your windows. Soap and water or automotive glass
cleaners may be used.
Winterizing
When the boating and ski season comes to an end, it is recommended that the boat be
removed from the water and stored. It is extremely important that proper winterizing
procedures are read and followed to ensure longer boat life. Here is our list of suggestions
to keep your boat in top condition:
• Prepare the engine according to the instructions found in your engine owner’s
manual. It our recommendation that you contact your local Axis dealer for full
winterization procedures.
• Clean and dry the boat interior and exterior thoroughly. Inspect boat hull for
residue and remove any if present.
• Clean the bilge area thoroughly and operate the bilge pump to remove any water
from bilge lines.
• Remove all seat cushions and open all storage areas. Store the seat cushions in a
cool and dry place.
• Cover the boat and store it in a garage or other protected facility.
• If the boat is stored on a trailer, you should block the trailer wheels.
Chapter 4_12_Axis_ Chapter 4 doc.qxd 9/21/11 3:24 PM Page 12
- Centered On You 1
- CONTENTS 4
- TABLE OF FIGURES 5
- INTRODUCTION 6
- MODEL FEATURES & 8
- BOATING SAFETY 10
- Safety Statements 11
- Regulations 12
- Responsibilities 12
- TYPE III 14
- KC-0009C-A 15
- KC-0250M 16
- KC-0461M 17
- Operation by Minors 18
- Passenger Safety 18
- Basic Rules of the Road 18
- Figure 1-6. Types of Buoys 19
- Figure 1-7. Mooring 19
- KC-0194C-A 20
- 12 O'CLOCK 20
- 4 O'CLOCK 20
- KC-0196C-B 21
- GAUGES & CONTROLS 22
- Figure 2-2. Tachometer 23
- Figure 2-3. Speedometer 24
- IGNITION SWITCH 25
- Figure 2-6. Inline Fuse 26
- Throttle Control 27
- Steering System 28
- Emergency Engine Stop Switch 28
- Motorbox Cover 28
- Driver’s Seat 29
- V-Drive Engine Access Hatch 30
- Ski Pylon 30
- Swim Platform 31
- Navigational Lights 31
- Storage Areas 32
- Drain Plugs 33
- Speedometer Pickup 33
- Tilt Steering Wheel 34
- Ventilation 35
- Optional Equipment 36
- Figure 2-27. Pull-Up 37
- Figure 2-28. FatAX 37
- Figure 2-29. Wedge Down 38
- Figure 2-30. Wedge Up 38
- Gauges & Controls 39
- OPERATION 40
- CRISSCROSS SAFETY CHAINS 41
- BOTTOM VIEW OF HITCH COUPLING 41
- Warning Labels 43
- Operation 44
- SWAMPING HAZARD 45
- Figure 3-7. Fueling 46
- KC-0027C-A 46
- Starting 47
- Shifting/Running 49
- KC-0199-A 50
- Stopping 51
- KC-0200C-A 52
- High-Speed Operation 53
- KC-0016C-A 54
- KC-0202C-A 55
- KC-2220M 56
- Figure 3-15 58
- Adjustable Rudder 58
- Corrosion Protection 59
- CARE AND 60
- MAINTENANCE 60
- Exterior 62
- Engine/Drive Train 63
- Engine Specifications 64
- Care and Maintenance 64
- HIGH (FULL) 65
- LOW (ADD) 65
- Figure 4-3. Dripless 66
- Shaft Seal 66
- Fuel System 67
- Electrical 68
- KC-0151C-A 69
- Figure 4-5. Battery Level 69
- Figure 4-6. Battery Switch 70
- Miscellaneous 71
- Troubleshooting 74
- Glossary 77
- Required Maintenance Schedule 80
- Indmar Engines 80
- AXIS WAKE RESEARCH LIMITED 82
- WARRANTY 82
- Limited Warranty 83
- How to Get Warranty Service 87
- Malibu Boats Limited Warranty 88
- Contact Information: 89
© 2020, manymanuals.com. All rights reserved. | 2.004 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals