Axis Wake Research Om 2012 Specifications Page 37

  • Download
  • Add to my manuals
  • Print
  • Page
    / 90
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 36
Pull-Up Cleats
Pull-Up cleats are available for all boat models. These
cleats will sit flush on the side of the boat deck when
depressed. To use the cleats, simply pull them up. Push
the cleats down to stow them.
Docking Lights
The docking lights should only be used during slow speed docking maneuvers. The lights
are activated by a switch on the accessory switch panel and have a 10 amp circuit
breaker. The docking lights use LED bulbs and cannot be replaced.
Tower
FatAX Tower (Standard)
This towers main hoop is made of oversized 3" tubing and
the bases are billet aluminum and through-bolted with
backing plates.
Properly stow the bimini top in its boot and remove all
boards from the board racks prior to towing/trailering your
boat. Damage to the bimini from towing while not stowed
is not covered under warranty. Damaged or excessive wear
to board racks caused by towing or trailering with boards
attached is not covered under warranty.
Due to vibration and rough water conditions it is possible for
bolts to loosen. Before each use, inspect all mounting bolts
(Tower, Wakeboard Racks, Lights, Speakers, etc.) to ensure
they are tight. See your local dealer for any questions and/or
assistance. Failure to do so can cause serious damage and/or
injury to the boat and/or passengers.
The tower is rated for a maximum of 130 lbs (58.9 kg) accessory weight and not more
than 600 lbs (272.1 kg) total rider weight. Exceeding these limits voids any structural
warranty pertaining to the tower. Approved activities for usage of the tower include
wakeboarding, wake skating, skiing or tubing.
Only factory pre-drilled holes should be used to install factory accessories on the tower.
The use of aftermarket accessories not supplied by Axis Wake Research may cause
damage not covered by the tower warranty. Drilling any additional holes in the tower will
void any structural warranty.
!
Figure 2-27. Pull-Up
Cleat
Figure 2-28. FatAX
Gauges & Controls
2-16
Chapter 2_12_Axis_ Chapter 2 doc.qxd 9/21/11 2:26 PM Page 16
Page view 36
1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 89 90

Comments to this Manuals

No comments