Axis Wake Research Om 2012 Specifications download pdf (Page 72)

Care and Maintenance

4-13

Storage and Winter Lay-up

Due to the problems that can occur from improper winterization, we recommend that you

take your boat to a certified Axis dealership to perform this task. Without proper

preparation, storage for long periods of time may cause parts of the engine and

transmission to rust due to lack of lubrication. Also, if your boat will be stored in freezing

conditions, water inside these components to include cooling system, heater and shower

could result in major damage to your boat. Damage done due to improper winter storage

will void your warranty. Here is our list of suggestions to keep your boat in top condition.

Prior to boat being removed from water:

• Fill fuel and add 1 ounce of STA-BIL

fuel stabilizer for each 5 quarts of

gasoline.

• Operate boat for at least 15 minutes in water or using a flush system to allow

treated fuel to flush engine.

• Add lightweight engine oil (SAE-10 or fogging oil) slowly to the engine while

engine is slightly above idle. Turn engine off. Consult your local dealer for

correct procedure.

To be completed when boat is put on trailer or resting cradle:

• Remove bilge T-handle and transom drain plug immediately after removing

from the water.

• Clean and dry the boat interior and exterior thoroughly. Inspect boat hull for

residue and remove if present.

• Clean bilge area thoroughly and operate the bilge pump to remove any water

from bilge lines.

• Remove all seat cushions and open all storage areas. Store the seat cushions in a

cool dry place.

• Apply coat of wax to entire surface of boat.

• Flush engine-cooling system with clean water. Do not exceed 1500 RPM while

flushing for 5-10 minutes.

• Turn fuel supply line to the OFF position (handle perpendicular to fuel line).

Perform annual scheduled maintenance. Refer to engine owner’s manual for

complete engine winterization procedures as well as scheduled maintenance.

Note: Damage done due to improper engine winter storage will void your warranty.

It is highly suggested that you allow a trained Axis technician to perform this

service.

• After performing engine winterization, remove engine safety switch and spin

engine over a few seconds to remove excess water found in pump bodies.

• Remove the negative cable from battery. Charge battery to fuel charge and

remove from boat.

• Clean all traces of dirt, oil and grease from engine, transmission and bilge. Coat

all areas on transmission and engine where paint has been removed with touchup

paint.

• Use duct tape to seal the exhaust flaps closed to prevent dirt and rodents from

entering exhaust.

• Remove propeller assembly, and store in safe place.

• If your boat is equipped with an optional heater or hot-water shower, remove

both hoses and blow through hose to remove excess water.

• Cover the boat with cover, tarp or, if available, shrink-wrap tarp. Also, due to the

excess weight that can occur from rain and snow for boats that are stored

outside, it is suggested that you make a support of 2 inch PVC piping that can be

mounted under the covering material. The rounded PVC piping will ensure the

cover does not tear and will eliminate pooling water inside boat.

Chapter 4_12_Axis_ Chapter 4 doc.qxd 9/21/11 3:24 PM Page 13

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 89 90

Comments to this Manuals

No comments

Axis Wake Research Om 2012 Specifications Page 72

Comments to this Manuals