Axis Wake Research Om 2012 Specifications download pdf (Page 26)

Navigation/Anchor Lights

In the ANC (anchor) position, this switch is used to activate the all-around light on the

tower. Keep the all-around light on after dusk whenever your boat is at rest in the open

waterway. While underway, place the switch in the NAV position to also activate the red

and green navigation bow lights.

Interior/Dash Lights

This switch is used to activate the interior lights. The interior lights include lights in the

gunnels, storage compartments, dashboard and optional underwater transom lights, if

equipped.

Blower

This switch activates the blower for the engine compartment. The primary function of the

blower is to eliminate any fumes in the motor compartment when starting the engine or

during idling.

Gasoline Vapors Can Explode. Before starting engine, operate

blower for 4 minutes and check engine compartment for

gasoline leaks or vapors. Run Blower below cruising speed.

Bilge Pump

The bilge pump switch is used to activate the bilge pump so that

any excess water in the bilge area may be drained out. You should

know that the bilge pump has a sensor in the bilge area and will

turn on automatically whenever 2 in. or more of water is detected.

The bilge pump is wired directly to the battery. This circuit can be

identified by an inline fuse from the battery labeled “Auto Bilge

Power.” If your boat takes on water for any reason, the auto bilge

pump will activate and continue to run until the water level drops

low enough to deactivate the pump. If water continues to enter the

boat, the pump will continue to run until the battery is drained.

Docking Lights

This switch is used to activate the docking lights. Only use

docking lights during slow speed docking maneuvers.

Ballast Switches

These switches are used to fill or drain the corresponding ballast tank. Press the top of the

switch to fill the tank. Press the bottom of the switch to drain the tank.

Accessory #1

This switch is used to supply power to the optional heater unit. (For information on the

use of the heater, please see Heater in the optional equipment section of this manual.)

Accessory #2

This switch is used to supply power to aftermarket accessories. Attaching an accessory to

this switch should only be done by a qualified technician.

2-5

Gauges & Controls

Figure 2-6. Inline Fuse

Chapter 2_12_Axis_ Chapter 2 doc.qxd 9/21/11 2:26 PM Page 5

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 89 90

No comments

Axis Wake Research Om 2012 Specifications Page 26