Axis Wake Research Om 2012 Specifications download pdf (Page 33)

Drain Plugs

Your Axis is equipped with two drain plugs; one located

at the transom of your boat and one T-handle located mid-

ship near the driver’s seat, reachable through the access

plate in the floor.

Transom Drain Plug

This plug is located in the center of the transom at the

bottom edge, and is provided to allow for drainage of the

bilge area, when needed.

Ensure all drain plugs are secure prior to launching your

boat. Damage caused as a result of these plugs not being

installed will not be covered under your Axis warranty.

Bilge Drain Plug

A T-handled, brass bilge drain plug is located in the bilge.

Location is mid-ship near the driver’s seat, reachable through

the access plate in the floor. The T-handle can be found by

removing the rear center seat and fiberglass compartment

cover under the seat. The T-handle is located just below the

V-drive unit.

Ensure that all transom and bilge

drain plugs are securely in place

before placing the boat in the water.

Speedometer Pickup

Your boat is equipped with a Paddle wheel speedometer

pickup, which can be found directly under the running

surface of your boat. The paddle wheel is used to measure

static water by rotation of the paddle wheel unit. This

information is transferred to the dash computer and a

computer program converts information which is

transferred to the speedometer gauge.

See Troubleshooting section of this manual for basic

maintenance information.

Figure 2-21. Transom Drain

Plug

Figure 2-23. Thru-Hull

Paddle Wheel Pickup

Gauges & Controls

2-12

Figure 2-22. Bilge Drain

Plug

Chapter 2_12_Axis_ Chapter 2 doc.qxd 9/21/11 2:26 PM Page 12

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 89 90

No comments

Axis Wake Research Om 2012 Specifications Page 33